Vivado Design Suite Reference Guide: Model-Based DSP

Chapter 3: System Generator Utilities

xlOpenWaveFormData

Allow you to populate saved simulation waveform data into running Waveform Viewer instance.

Syntax

xlOpenWaveFormData(‘C:/wavedata/model_name.wdb’)

How to Use

1. Make sure an instance of Waveform Viewer is opened in the current SysGen session.

2. Locate the waveform data file (model_name.wdb) you would like to open.

Note:

Note: Waveform data are saved under the wavedata directory.

3. Type xlOpenWaveFormData(‘C:/wavedata/model_name.wdb’) in the MatLab console.

Make sure you enter the absolute path of the waveform data file.

4. Observe the waveform data in Waveform Viewer

See Also

Xilinx Waveform Viewer

Vivado: Designing with System Generator

UG958 (v2015.4) November 18, 2015 www.xilinx.com

Send Feedback

399