GDB command files UM1250
2.75 sti7200jtag.cmd
Defines the commands for configuring the connection between an STMC1 or an STMCLite and the ST40 CPU of an STi7200, see
Table 93
.
Note:
Table 93.
sti7200jtag.cmd
Command Description
sti7200_bypass_setup sti7200_bypass_setup_attach sti7200_stmmx_setup
(2) sti7200_stmmx_setup_attach
Configure the STMC for a direct connection to the ST40
CPU.
Similar to sti7200_bypass_setup except that the
STi7200 is not reset. Used when attaching to a running or stopped target.
(1)
Configure the STMC1 for a connection to the ST40 CPU using an ST MultiCore/MUX device allowing simultaneous access to the ST40 and other CPU’s on the STi7200.
Similar to sti7200_stmmx_setup except that the
STi7200 is not reset. Used when attaching to a running or stopped target.
(1)
1.
See
Section 2.78: sh4targets-attach.cmd on page 67
and
Section 2.79: sh4targets-attach-debug.cmd on page 69
.
2.
Only supported by the STMC1.
The $STi7200ResetDelay GDB convenience variable is used by the commands listed in
Table 93
to set the delay (in milliseconds) when performing a reset of the target. The default
is 20 milliseconds.
2.76 stv0498jtag.cmd
Defines the commands for configuring the connection between an STMC1 or an STMCLite and the ST40 CPU of an STV0498, see
Table 94
.
Note:
Table 94.
stv0498jtag.cmd
Command Description
stv0498_bypass_setup
Configure the ST Micro Connect 1 for a direct connection to the ST40 CPU.
stv0498_bypass_setup_attach
Similar to stv0498_bypass_setup except that the
STV0498 is not reset. Used when attaching to a running or stopped target.
(1)
1.
See
Section 2.78: sh4targets-attach.cmd on page 67
and
Section 2.79: sh4targets-attach-debug.cmd on page 69
.
The $STV0498ResetDelay GDB convenience variable is used by the commands listed in
Table 94
to set the delay (in milliseconds) when performing a reset of the target. The default
is 20 milliseconds.
66/87 8045872 Rev 9
