S40-T

1.13 Information menu

Press UP button to enter Information Menu

Configuration

Maximum

Minimum

Alarm1

Sensor type

ºC or ºF

Hysteresis

Delay

Setpoint2

Memory of maximum

Memory of minimum

“On / Off”

“Max” / “Min”

Setpoint

User’s Manual S40-T

Counts

Seconds

Second setpoint

1.13.1 Information menu

Configuration (Conf) - Information on the configured input sensor and the degrees selected.

Maximum (MAX) - Value of the maximum display.

Minimum (MIn) - Value of the minimum display.

AlarmX (ALX) - Configuration of alarm X. The sequence of information shows if the alarm is being managed (“On/Off”), the alarm type (“Max/Min”), the setpoint, the hysteresis value, the activation delay and the value of setpoint2 (“Off” or the setpoint2 value).

OptionX (OptX) - Type of module installed. If there is no module shows “nonE”.

1.14 Accessing the instrument

You may need to access the inside of the instrument to insert additional modules. Use a flat screwdriver to unlock the upper clips marked with “A”. Then unlock the lower clips marked with “B” and move out the front filter. Let the inside of the instrument slide out of the housing.

To reinsert the instrument make sure that all modules are correctly connected to the pins on the display module. Place all the set into the housing, assuring that the modules correctly fit into the internal guiding slides of the housing. Once introduced, place again the front filter by clipping first the upper clips “A” and then the lower clips “B”.

Option1

Option2

See menu for Alarm1

Option installed

Option installed

A

B

Risk of electric shock. Removing the front cover will grant access to the internal circuits. Disconnect the input signal to prevent electric shock to the operator.

Operation must be performed by qualified personnel only.

FEMA ELECTRÓNICA - Page 10