advertisement
BBG-1090-ENC Indicators and Switches
The BBG-1090-ENC can be used as a desktop encoder, or in a 19” rack-mount tray that holds up to three units:
Back Panel
The BBG-1090-ENC ships with one of two possible back panels:
•
Unbalanced Audio Back Panel
•
Balanced Audio Back Panel
The panels are depicted in the next page.
Both panels include two software-configurable Composite/SDI video inputs on standard BNC connectors, two streaming 100/1000 Mb/s Ethernet ports on standard RJ-45 connectors, and two control 10/100/1000 Mb/s Ethernet ports on standard RJ-45 connectors, in addition to the analog audio connectors. In the unbalanced version (BBG-1090 … -U), the analog audio connectors are standard RCA jacks; in the balanced audio version (BBG-1090 … -B), the analog audio connectors are terminal blocks.
Unbalanced Audio Version (-U part number suffix)
L AUD1 R VID1
I
0
CTRL1 ETH1
L AUD2 R VID2
CTRL2 ETH2
Control
Ethernets
Streaming
Ethernets
Unused
Ports
12
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Contents
- 7 Safety Instructions for the BBG-1090-ENC-H264-IP Appliance
- 7 Electrostatic Discharge (ESD) and ESD Protection
- 7 Safety Notice and Warnings
- 7 FCC Notice
- 7 Other Certifications
- 8 CE Mark Warning
- 8 Installation Safety Notes
- 10 Introduction
- 10 Product Overview
- 12 BBG-1090-ENC Indicators and Switches
- 12 Back Panel
- 13 Front Panel Indicators
- 14 Front Panel Default Switch
- 16 BBG-1090-ENC Operation and Management
- 18 Product Tab
- 20 Network Tab
- 20 Network Configuration Tab
- 20 Network Configuration Interfaces Tab
- 21 Network Configuration DNS Tab
- 22 Network Statistics Tab
- 22 Network Statistics Interface Tab
- 23 Network Statistics DNS Tab
- 24 Encoder 1, Encoder 2 Tabs
- 24 Encoder Configuration Tab
- 25 Video Input Auto-Detection
- 25 Encoder Basic Configuration Tab
- 26 Basic Tab – General Configuration
- 27 Basic Tab – Video Configuration
- 31 Basic Tab – Audio Configuration
- 33 Encoder Advanced Configuration Tab
- 33 Advanced Tab – Video Parameters
- 35 Advanced Tab – VBI/Ancillary Data Insertion
- 39 Advanced Tab – Audio Parameters
- 41 Advanced Tab – Mux Parameters
- 43 Encoder Output Tab
- 44 UDP/IP Streaming
- 45 HTTP Live Streaming
- 49 Direct HTTP Streaming
- 54 The Apply/Cancel Buttons
- 55 Encoder Statistics Tab
- 55 Encoder Status
- 59 Output Status
- 63 Admin Tab
- 63 Admin General Tab
- 64 Admin Firmware Tab
- 66 Admin Config Files Tab
- 66 User-Saved Configurations
- 68 Pre-defined Templates
- 69 Clear Current Configuration Button
- 69 Admin Event Log Tab
- 73 Support Tab
- 74 Control Tab
- 74 Control Port Configuration Tab
- 75 Control Port Statistics Tab
- 76 SNMP Configuration Tab
- 77 SNMP Statistics Tab
- 78 Playing Video on a Web Page
- 79 Web Pages Served by the device
- 81 Multicast Streaming
- 81 HTTP Live Streaming
- 82 Direct HTTP Streaming
- 82 Using a Firewall between the Device and the Internet
- 83 Web Browser Support