PC Cards CIFX 104

Device Drawings

System-LED

(gelb/grün) /

(yellow/green)

SYNC-Anschluss /

SYNC Connector

(X51, 3-polig /

3 pin

)

41/171

Steckbrücke Datenbusbreite 8 Bit und 16 Bit

(J9, im Bild Einstellung Steckbrücke für 16 Bit)

Data Bus Width Jumpers 8 Bit and 16 Bit

(

J9,

Jumper Settings for 16 Bit shown)

Kabelstecker Ethernet /

Cable Connector Ethernet

(X4, 20-polig /

20 pin

)

Kabelstecker DIAG /

Cable Connector DIAG

(X3, 12-polig /

12 pin

)

PC/104-Bus /

PC/104 Bus

(X1, 64-polig /

64 pin

)

(X2, 40-polig /

40 pin

)

Interrupt-Steckbrücke /

Interrupt Jumper

(J8, 11-polig /

11 pin

)

Adresssteckbrücke /

Address Jumpers

(J7, 7-polig /

7 pin

)

Standardeinstellungen Steckbrücken /

Default Jumper Settings

Figure 4: Basic Card for CIFX 104-RE\F

Note:

ƒ If the assembly inter face diagnostic

AIFX-DIAG

is connected to the basic card for the PC card CIFX 104-RE\F or CIFX 104-RE-R\F, the

Mini-B USB

connector on the AIFX-DIAG can be used beginning with the hardware revision 5 of the PC card cifX.

ƒ In

Interrupt Mode

(IRQ = Interrupt Request) exactly one jumper must be set. If no jumper is set, the PC card cifX works in

Polling Mode

.

For further details refer to

Table 23: Starting Address and Interrupt for

16 KByte Dual-Port Memory

on page 59.

ƒ For the pin assignment of the

PCI/104

bus X1/X2 refer to section

Pin

Assignment for PC/104 Bus

on page 104.

ƒ For the pin assignment of the

SYNC

Connector refer to section

Pin

Assignment SYNC Connector, X51

on page 102.

PC Cards cifX PC/104 | Installation, Operation and Hardware Description

DOC120206UM44EN | Revision 44 | English | 2015-07 | Released | Public © Hilscher, 2008-2015