smt361 user manual

Version 2.7 Page 11 of 23 SMT361 SMT361A User Manual

Version control

Revision numbers for both the boot code and FPGA firmware are stored in the Flash

ROM during programming as zero-terminated ASCII strings.

The SMT6001 utility is to be used to know the version of the boot code and the

FPGA.

Reprogramming the firmware and boot code

The reprogramming is made using the SMT6001 utility. It comes with the latest firmware and boot code for the module and with a complete documentation on how to reprogram a module. It requires only the correct set-up for code composer (see code composer section).

To confirm that the programming has been successful you should use the Sundance

Server to reset the board and execute the confidence test using SMTBoardInfo.

Interrupts

See general firmware description

Communication ports

The SMT361 provides 4 ComPorts. They are ComPorts 0, 1, 3 and 4.

ComPorts 2 and 5 are interconnected on the module to allow a bypass to the next module.

See general firmware description