smt361 user manual

Version 2.7 Page 14 of 23 SMT361 SMT361A User Manual

Code Composer

This module is fully compatible with the Code Composer Studio (CCS) debug environment. This extends to both the software and JTAG debugging hardware. You will require updating to version 2.2 or later.

The name of the C64xx CCS device driver is tixds6400.dvr for silicon revision 1.01 and tixds6400_11.dvr for silicon revision 1.1, and should be obtained from Texas

Instruments. In case of difficulty please log onto Sundance’s support forum http://support.sundance.com/

WARNING:

From the silicon errata sprz011g.pdf

from Texas Instrument:

Revision(s) Affected: 1.03 and earlier

Details: The JTAG port does not work properly if non-C64x devices are in the scan chain with the C64x device.

Workaround: Place all C64x devices in a separate scan chain.

FIRST TIME DOWNLOAD

When you open CCS and want to download an application, after power up, you might get the following error message:

“Can’t set breakpoint: Cannot set/verify breakpoint at 0x8C40” (the address might be different)

Workaround: Reset the board first with a server or you should infer a CPU Reset from Debug\reset CPU. Then you should run the processor.

You can then stop the processor and load your application