Install the Motor Cover and Spinner. GREAT PLANES Escapade Mx

Install the Motor Cover and Spinner

❏

3. Next use clear tape to secure the brushless cover’s sides to the fuselage sides.

❏

1. Place the included balsa stick on the nose of the Escapade

MX as shown. Test fi t the brushless cover so that it lines up with the trim on the aircraft. It may be necessary to remove the balsa stick and trim the length so that the brushless cover’s width fi ts properly with the aircraft’s nose.

❏

4. Use a felt tipped marker to mark the locations for the brushless cover’s securing screws which will go through the brushless cover and into the plywood stick.

❏

2. Once you’ve achieved a good fi t, use CA to secure the stick in the position on the nose.

12

❏

5. Using a 1/16 drill bit, drill the two holes. Remember to tap the two holes and use thin CA to harden the plywood.

Install the two #2 x 3/16" self-tapping screws along with the

#4 washers.