advertisement
2) Adjusting air volume to the height of ceiling
You can choose the RPM(or air volume) of indoor motor according to the height of ceiling to supply the comfortable atmosphere to consumers.
Procedure
1. Choose the selectable position in the table after measuring the height of ceiling.
Remark Ceiling height more than 4.0m
3.2~4.0m
less than 3.2m
Mode of slide switch
High Ceiling
Standard
Low Ceiling
Change of air volume
Increasing
-
Decreasing
Maunfactured in standard mode
2. In the case of changing the height as "high" or "low", open the rear cover of the wired remote-controller.
3. Move the slide switch to the set position.
Slide switch for 2 Thermistor
Low ceiling
Standard
(Default)
High Ceiling
STAND
Lo
Hi
Slide switch for ceiling height
TH R13H R12H
CO1H
OP5R16H OP4
R15H
R14H
OP3
SW TH
OP2 OP1
R19H
R11H
REMO
MAIN
2TH
R17H
OP7
R18H
OP6
STAND
LO
HI R03S
R01S
SW HIGH
4. Close the rear cover and check if it works nomally.
18
advertisement
Related manuals
advertisement
Table of contents
- 3 1.The following should be always observed for safety
- 4 2.Installation of Indoor, Outdoor Unit
- 4 1) Selection of the best location
- 5 bolt location(unit: mm)
- 6 3) The Indoor Unit Installation
- 6 4) Remote Controller Installation
- 8 5) Wiring Connection
- 9 ELECTRICAL WIRING
- 9 CONNECTING THE CABLE TO OUTDOOR UNIT
- 10 6) Connecting Pipes to the Indoor Unit
- 11 PIPING CONNECTION
- 12 7) Installation of Decorative Panel
- 13 8) Indoor Unit Drain Piping
- 14 HEAT INSULATION
- 14 FORM THE PIPINGS
- 15 3. Test running
- 15 1) PRECAUTIONS IN TEST RUN
- 15 INSTALLATION IS COMPLETE
- 16 2) Connection of power supply
- 16 3) Evaluation of the performance
- 17 4. Auxiliary operation
- 17 1) Two thermistor system
- 18 2) Ajusting to the height of ceiling
- 19 3) Group control (optional wiring)
- 20 4) Central control (optional)