NAD T562 User Guide Manual Operating Instruction Pdf

T562 IM english 23/7/02 9:43 am Page 22

Setup

CONNECTING TO AN ANALOGUE STEREO SYSTEM

Good quality sound of 2-Channel Stereo system can be achieved by connecting this DVD player to a receiver equipped with a two analogue audio inputs (right and left) and speaker system (right and left front speakers).

From S-VIDEO / Component Video /

Composite or SCART

S-VIDEO / Component / Composite

75–Ohm coaxial or SCART cable

From the MIXED AUDIO OUT

(L & R) Jacks

To S-VIDEO / Component /

Composite or SCART inputs of the TV.

Audio cable

TV or monitor with audio/visual inputs

To the analogue input (L & R) amplifier equipped with analogue inputs.

Audio system

TO ENJOY GOOD QUALITY SOUND

You need to select from the OSD drop down menu, Audio, Analogue On, and 48K.

NOTES

• Switch the power off on the T562 before switching the SCART/S-VIDEO switch position.

• Refer to the owner’s manual of your receiver as well.

• Before you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.

• The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

• Turn off the receiver before you connect or disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.

22

Downloaded From DvDPlayer-Manual.com NAD Manuals