SL830

✔

• If “TIMING” is set to

FRAME (see step 6),

“FRAME” will be indicated instead of “FIELD”.

• In case of TimeLapse mode, refer to the

“Recording Speed” Table of page 14.

Setting the SW Out Terminal Output

Synchronization pulses for a multiplexer can be obtained from the SW OUT terminal.

1 Press the MENU button, to display the initial MENU.

2 Press the SHIFT button to move the arrow mark

( ) to SW OUT Terminal Set.

3 Press the SHIFT button to display the SW OUT

TERMINAL SET menu.

4 Press the SHIFT button to set “FIELD” (or

“FRAME”).

• With each press of the SHIFT button, the setting will change as indicated below.

5 Press the SHIFT button, to select Timing.

6 Press the SHIFT button to set the “TIMING”.

• AUTO . . . When you connect with external equipment, the field will be switched automatically.

• FIELD . . . 1 pulse is output after each set number of fields. (VHS mode, 2H, 6H)

• FRAME . . 1 pulse is output after each set number frames.

(VHS mode, 2H, 6H)

7 Press the MENU button, the normal screen is displayed.

• The setting procedure is now complete.

34

Time Lapse Video Cassette Recorder

✔

• For RS-232C connection and operation with a computer, please refer to the additional RS-232C serial communication manual.

RS-232C Setting

You can control this set in remote by communication with Computer.

• Communication speeds (baud rates) can be set on your computer screen while the Secunet software program is running. Access the top tool bar,

Setting/Set/Speed to change the speed to best match your computer’s settings.

✔

In the following cases, the buzzer will be heard approximately 5 times.

- If the REC button is pressed while a cassette without erasure-prevention tab is loaded.

- If a cassette, without the erasure - prevention tab, is loaded while the timer is set.

- If there is a series recording input while a cassette without erasure-prevention tab is loaded.

- If the TIMER button is pressed without inserting a cassette.

✔

• If “NO” is set, the buzzer will not operate.

Setting the Buzzer

1 Press the MENU button to display the initial MENU.

2 Press the SHIFT button to select VCR Mode Set.

The VCR MODE SET menu is displayed.

3 Press the SHIFT button to move the arrow mark

( ) to Buzzer Set.

4 Press the SHIFT button to set “YES” for the functions described below.

• The buzzer will be heard whenever a button is pressed.

Time Lapse Video Cassette Recorder

35