advertisement
To tilt the headstock to the left or right:
1. DISCONNECT THE MILL/DRILL FROM POWER.
2. Using a 17mm wrench, loosen both head stock tilt acorn lock nuts ( Figure 16).
3. Insert a 6mm hex wrench into the index pin release port ( Figure 16), and turn the hex wrench clockwise to disengage the spring loaded index pin from the headstock.
4. While watching the tilt scale, rotate the head stock to the required angle, and retighten the tilt acorn lock nuts to hold the headstock in place.
Note: The index pin is spring loaded and
serves only as a quick way to return the headstock close to zero. It is not intended to be an absolute zero degree stop. No other index holes exist at other angles in the head stock.
Tilt Scale Index Pin Release Port Headstock Tilt Acorn Lock Nut
Table Travel (X-Axis and Y-Axis)
The table can be moved in the X-axis and Y-axis.
Longitudinal Feed
The longitudinal feed or (X-axis) is moved by the handwheel shown in table (see Figure 18).
Figure 17 at the end of the table. The handwheel will move the table in both directions side-to-side. One complete revolu tion of the handwheel moves the longitudinal feed 0.100". There is also a scale on the front of the table for use when a tight tolerance is not required. The longitudinal feed can be locked in position by a table lock located on the front of the
Cross Feed
The cross feed or (Y-axis) in Figure 17, is moved with the handwheel on the front of the table base. One complete revolution of the handwheel moves the cross slide 0.100". The cross feed can be locked into position by a table lock located on the right side of the cross slide underneath the table (see Figure 18).
Y-Axis Handwheel X-Axis Handwheel -22 Figure 16. Headstock tilt controls.
Figure 17. Table X and Y-axis controls.
X-Axis Table Lock Lever X-Axis Scale Y-Axis Table Lock Lever Y-Axis Scale Figure 18. Table locks and scales.
Model G0619 (Mfd. Since 7/18)
advertisement
