™ M-Series. Datalogic GRYPHON, Gryphon M200, Gryphon D100, Gryphon M100, Gryphon D200

REFERENCES

5.10.2 Copy GRYPHON

™ M-Series

Procedure: c Using the slave reader and its OM-Gryphon™ cradle, follow the initialization

procedure in chapter 4 of this manual or from the Quick Reference Manual.

d With the master Gryphon™ M (correctly configured reader), read the Copy

Configuration barcode below. Then place it onto an OM-Gryphon™ cradle within

10 seconds. The reader will beep indicating the configuration has been copied.

The configuration will be simultaneously sent over the RS232 interface of the

OM-Gryphon™. If this causes undesired effects disconnect the RS232 cable between the PC and OM-Gryphon™ during this process.

Copy Configuration

Ì$+ZZ0$-*Î

e With the slave Gryphon™ M, read the Get Configuration barcode below. Then place it onto the same OM-Gryphon™ cradle used in the step above. The slave reader's address will not be changed.

Get Configuration

Ì$+ZZ2$-4Î

The configuration will be copied from the master to the slave Gryphon

™ M. The slave Gryphon

™ M signals the end of the procedure with a series of beeps. It is now ready to be used with its own OM-Gryphon™ cradle. f Repeat the procedure above to configure other slave readers. The

OM-Gryphon™ can continue to configure slave readers until it receives another command or data.

155