C-GRYPHON™ Configuration. Datalogic GRYPHON, Gryphon M200, Gryphon D100, Gryphon M100, Gryphon D200

REFERENCES

5.11 C-GRYPHON™ CONFIGURATION

Battery selection is required only when the Gryphon™ M reader has an Alkaline battery and you want to use C-Gryphon™ either for serial configuration, software upgrades or to hold Gryphon™ M. Since this type of battery must not be charged it is necessary to disable the C-Gryphon™ charge function by following the procedure:

1.

With the Gryphon™ M read the following code:

Alkaline

Ì$+RN4$-]Î

The green LED on the Gryphon™ M will blink, signaling the reader has accepted the command.

2.

Place the reader onto the charger within 10 seconds. The green LED turns off and a short beep is emitted

To enable the charge function repeat step 1 and 2 substituting the "Alkaline" code with the following one:

NiMh/NiCd

Ì$+RN6$-gÎ

CAUTION

Attempts to charge Alkaline batteries could cause leakage of liquid, generation of heat or, in extreme cases, explosion. If using Alkaline batteries, carefully follow the procedure above to avoid damage.

157