6. Operation Controls and Functions. CYP CH-506RX, CH-506TX
Add to My manuals16 Pages
CYP CH-506RX is a high-performance HDBaseT™ HDMI extender that transmits uncompressed audio/video and control signals over a single CAT5e/6/7 cable. It supports HD resolutions up to 1080p@60Hz and Ultra HD (4K2K) resolutions up to 40m (3D) or 20m (4K2K). The extender also features 2-way IR and RS-232 pass-through, allowing you to control your HDMI source device from a remote location. With its compact size and easy installation, the CYP CH-506RX is the perfect solution for a variety of applications, including home theater, digital signage, and video conferencing.
advertisement
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
IR2 Extender
DC 5V
HDMI In
7
Power
Link
RS232 In IR1 Blaster
Rear
CAT 5e /6 Out
1 2 3 4 5 6 8
1
RS232 In: Connect to a PC/laptop or RS-232 enabled device
(with supplied 3.5 mm mini-jack to D-sub 9-pin adaptor) for the transmission of RS-232 commands.
2
IR2 Extender: Connect to the supplied IR extender cable for IR signal reception. Ensure that remote control being used is within the direct line-of-sight of the IR extender.
3
IR1 Blaster: Connect to the supplied IR blaster cable for IR signal transmission. Place the IR blaster in direct line-of-sight of the equipment to be controlled.
4
HDMI In: Connect to the HDMI source equipment such as a DVD or
Blu-ray player.
5
DC 5V: Connect the 5 V DC power supply to the unit and plug the adaptor into an AC outlet.
6
Link LED: The yellow LED will illuminate when both the input and output CAT5e/6/7 signals are connected.
7
Power LED: This green LED will illuminate when the device is connected to a power supply.
8
CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6/7 cable for transmission of all data signals.
3
advertisement