6 SPEAKER MICROPHONE. ICOM IC-F9011T, IC-F9011S

■

Optional HM-184 description

Microphone

Speaker

Belt clip

PTT SWITCH

Push and hold to transmit; release to receive.

SPEAKER MICROPHONE

6

■

To attach

Attach the connector of the speaker-microphone into the multi connector on the transceiver and tighten the screw with a coin or flat head screwdriver.

Turn the transceiver power OFF while connecting the HM-184.

NEVER immerse the connector in water. If the connector becomes wet, be sure to dry it BEFORE attaching it to the transceiver.

NOTE: The microphone is located as shown in the diagram above. To maximize the readability of your transmitted signal (voice), hold the microphone approx. 5 to 10 cm (2 to 4 inches) from your mouth, and speak in a normal voice level.

Screw

Coin

CAUTION: Attach the multi connector properly, but do not overtighten.

A loose connection will allow water intrusion into the connector; an overtightened connection will damage the connector pins in the transceiver.

IMPORTANT: KEEP the connector cover attached to the transceiver when the speaker-microphone is not in use.

(p. 3)

Water will not get into the transceiver even if the cover is not attached; however, the terminals (pins) will become rusty, or the transceiver will function abnormally if the connector gets wet.

13

14

15

16

9

10

11

12

7

8

5

6

3

4

1

2

22