INSTALLING THE BATTERY. Electrohome CR35, CR35W

OPERATING INSTRUCTIONS

INSTALLING THE BATTERY

1. Using a small Phillips Head screwdriver, remove the screw from the battery panel on the bottom of the unit.

2. Remove the battery compartment panel.

3. Remove/properly dispose of depleted battery and replace with new, 3V, CR2032

Flat Lithium battery.

4. Close the battery compartment and put screw into place to secure battery panel.

3V, CR2032 Battery

Philips Head Screw

Batteries must be installed by an adult.

Use only the recommended size and type of battery specified.

Please be sure to follow the correct polarity when installing the battery in the battery compartment. A reversed battery may cause damage to the alarm clock.

When not using the unit for a prolonged period of time, please remove the batteries to avoid possible damage caused by leaking batteries.

ATTENTION

• When replacing the battery, do not disconnect the AC plug from the AC outlet. Current time and alarm will be initialized.

• Do not plug or unplug the power cable if you have wet hands.

• If you are not planning to use the unit for an extended period of time, disconnect the power cable from the wall outlet.

•

Do not pull on the cord! You may damage the power cord and may cause an electric shock when disconnecting the power cord from the wall outlet. Pull firmly at the base of the plug.

- 14 -

OPERATING INSTRUCTIONS