advertisement
▼
Scroll to page 2
of
32
5BInstallation
6.2 Installation
6.2.1 Fixation
FDM221
1.
Install the housing at a height of 1.3
… 1.6 m on an even surface.
2.
Pull the cables through the entry opening(s) into the housing.
3.
For surface mounting, use screwed cable glands (max. M20 with nut).
FDM223/FDM224
1.
Install the housing at a height of 1.3
… 1.6 m on an even surface. In wet areas, only use the screw holes marked by arrows (see figure below).
2.
Pull the cables through the entry opening into the housing.
3.
For surface mounting, use screwed cable glands (max. M20).
Fire Safety & Security Products
17
007002_e_en_--.doc
11.2007
advertisement
Related manuals
advertisement
Table of contents
- 5 About this document
- 7 Safety notes
- 7 Signal words and symbols
- 7 Classification and meaning of signal words
- 7 Symbols and their meaning
- 7 Classification and meaning of additional symbols
- 8 Safety-relevant working instructions
- 9 Overview
- 10 Setup and function
- 10 Manual call point FDM
- 13 Diagnosis levels
- 14 Accessories
- 15 Project planning
- 16 Installation
- 16 Preparation
- 17 Installation
- 17 Fixation
- 18 Inserting the protective cover
- 19 Electric connection
- 21 Commissioning
- 21 Localization and device test
- 21 Performance check
- 23 Maintenance / Troubleshooting
- 23 Status retrieval
- 23 General maintenance work
- 23 Resetting
- 25 Replacing the glass pane
- 27 Spare parts
- 28 Specifications
- 28 Technical data
- 30 Dimensional drawings
- 30 Dimensions
- 30 Master gauge for recesses
- 30 Environmental compatibility