6. Operation Controls and Functions. CYP CHDBT-1H1CE, CHDBT-1H1CL, HDBaseT 1x2 HDMI over CAT5e/6/7 Transmitter-Splitter

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

HDMI OUT HDMI IN

RS232 IN

HDMI to CAT5e/6 with LAN/IR/RS232

1 2

LAN

3

Transmitter

4

1

HDMI OUT: Connect to a HDMI display for local monitoring of the

HDMI signal or cascade to another Splitter.

2

HDMI IN: Connect to an HDMI source device such as DVD/Blu-ray player or games console.

3

LAN: Connect to an active network for LAN serving. When any compatible LAN equipped receivers are connected, this allows the network access (including internet access if available) to be shared. Connect any Ethernet equipped device e.g. a Smart TV or games console to the LAN port of a receiver for that device to share the network/internet access.

Warning: DO NOT connect the LAN connection to the CAT5e/6/7 output, doing so may trigger a power shut down and may damage the device.

4

RS-232 IN: Connect to a PC/Laptop or RS-232 control device (with the supplied 3.5mm mini-jack to D-Sub 9-Pin adaptor) to transmit

RS-232 data to a suitably equipped receiver unit.

Note: This device has a last memory function and will retain the

EDID settings of the last device connected via the CAT5e/6 output port when it is not connected to a display after power cycling.

The splitter will read the EDID settings of the device connected

to the HDMI output of the receiver unit and if it detects a 4K×2K

capable EDID it will transmit the signal in that format to the output

port. If no 4K×2K capable EDID is detected then the unit will detect

the EDID settings and send out the signal that all outputs can accept.

3