advertisement
Alternate Priming Method
Alternate Priming Method
4.
Hold sprayer above sink or waste area, disengage the trigger lock, and quickly trigger sprayer until material comes out of the drain tube.
1.
Engage trigger lock and put prime/relief valve UP to release pressure.
ti14995a ti14991a ti14994a ti14999a
2.
Remove material cup and fill with flushing material.
NOTE: Material can shoot out of the drain tube
when performing this procedure. Be sure to wear appropriate safety equipment and point drain tube away from yourself when pulling the trigger,
5.
Thread the material cup back onto sprayer.
3.
With sprayer in prime mode, turn sprayer upside-down, remove strainer and slowly pour flushing material into the intake tube until full.
6.
Trigger the gun for 10 seconds then release the trigger and put the prime/relief valve DOWN to spray position. ti15425a
7.
Reverse spray tip to UNCLOG position and spray into waste area for five seconds to ensure sprayer has primed.
3A0159D
ti14995a ti14991a
8.
Sprayer is now ready to spray. Follow Starting New
Job instructions on page 12.
23
advertisement
Related manuals
advertisement
Table of contents
- 2 Table of Contents
- 2 Important User Information
- 2 Read this before using your sprayer. See the Operation Manual provided with your sprayer for complete instructions on proper use and safety warnings.
- 3 Warnings
- 6 TrueCoat™ Component Identification
- 7 TrueCoat™ Plus Component Identification
- 8 Using Electrical Cords
- 8 Grounding and Electrical Requirements
- 8 Power Cord
- 8 Extension Cord Requirements
- 9 Common Procedures
- 9 Pressure Relief Procedure
- 9 Trigger Lock
- 9 Spray Tip Position
- 9 Control Lever Position
- 10 Setup
- 10 Overheating Protection
- 10 Installing Suction Tube
- 10 Spraying Stains or Clear Coats (Fine-Finish Optimizer)
- 11 Sprayer Setup
- 13 Install Tip/Guard Assembly (if not installed)
- 13 Shoulder Strap Installation
- 14 Basic Spraying Techniques
- 14 Triggering Sprayer
- 14 Aiming Sprayer
- 15 Unclogging Spray Tip/Guard Assembly
- 16 Shutdown and Cleaning
- 16 Flushing Sprayer
- 18 Cleaning Sprayer Exterior
- 18 Tips
- 18 Storage
- 19 Replacement Parts and Kits
- 20 Troubleshooting
- 23 Alternate Priming Method
- 24 Inlet Valve Cleaning
- 25 Technical Data
- 26 Notes
- 27 Notes
- 28 Graco Standard Warranty
- 28 For the latest information about Graco products, visit www.graco.com. Contact Graco Customer Service at 1-888-541-9788.