advertisement
Installation
Hardware Installation
• Make sure you have a personal computer with an open USB port before connecting the drive to your computer.
• Power for all devices should be turned off before attaching the cables.
Connect the drive to the computer and to a camcorder, VCR or video device with with Audio/Video cables or S-video cable(not supplied.) as shown in figure.
A. Connecting to Computer
1. Connect the USB converter cable to the External Super Multi DVD
Rewriter.
2. Connect the other end of the USB converter cable to your computer.
3. Connect the AC adapter plug to the power connector at the rear of the drive.
Attach the AC adapter to the AC wall outlet.
4. When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Super Multi DVD Rewriter and install the software.
OR
B. Connecting to Camcorder or
Video Device
1. Connect the Camcorder or Video device.
Refer to the manual supplied with the device to be connected.
NOTE
If your Video device is equiped with S-Video output, you can connect an RCA cable from the audio output of the video device to the audio input of the drive, and S-Video cable from the S-Video output of the video device to the S-Video input of the drive.
6
advertisement
Related manuals
advertisement
Table of contents
- 5 Features
- 5 Package contents
- 6 System requirements
- 7 Important precautions
- 8 Location and function of controls
- 9 Hardware Installation
- 10 Removing the USB converter cable
- 11 Loading and ejecting a disc
- 12 Recording
- 13 Playing a music CD
- 13 Playing DVD video and MPEG2 movie video
- 14 Troubleshooting
- 15 Specifications