advertisement
CONTROLS AND THEIR FUNCTIONS
Front panel
SUBWOOFER SYSTEM YST-SW015
STANDBY/ON B.A.S.S.
HIGH CUT50–150Hz VOLUME 0–10
SUBWOOFER SYSTEM YST-SW015
STANDBY/ON B.A.S.S.
HIGH CUT50–150Hz VOLUME
0–10
Port
1 2 3 4 5
6
110V–120V 220V–240V
VOLTAGE
SELECTOR
ON
POWER
OFF
7
Rear panel (General model)
/MONO
INPUT
AUTO
STANDBY
PHASE
OFF LOW HIGH NORM REV
ON
POWER
OFF
110V–120V 220V–240V
VOLTAGE
SELECTOR
/MONO
INPUT
AUTO
STANDBY
PHASE
OFF LOW HIGH NORM REV
8 9 0
1
Power indicator
Lights up in green while the subwoofer is on.
Lights up in red while the subwoofer is set in the standby mode by the operation of the automatic powerswitching function.
Goes off when the subwoofer is set in the standby mode.
2
STANDBY/ON button
Press this button to turn on the power when the
POWER (
7
) switch is set in the ON position. (The power indicator lights up in green.)
Press again to set the subwoofer in the standby mode.
(The power indicator goes off.)
Standby mode
The subwoofer is still using a small amount of power in this mode.
3
B.A.S.S. (Bass Action Selector System) button
When this button is pressed in to the MUSIC position, the bass sound in audio software is well reproduced.
By pressing the button again so that it pops out at the
MOVIE position, the bass sound in video software is well reproduced.
MOVIE MUSIC
4
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
90 Hz
80 Hz
100 Hz
110 Hz
120 Hz
70 Hz 130 Hz
60 Hz
50 Hz
140 Hz
150 Hz
5
VOLUME control
Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume.
6
VOLTAGE SELECTOR switch
(For China, Korean and General models)
If the preset setting of the switch is incorrect, set the switch to the proper voltage range (220V-240V or
110V-120V) of your area.
Consult your dealer if you are unsure of the correct setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
E-
5
SW015(UB) (03.2.28)a 5 03.2.28, 7:25 PM
advertisement
Related manuals
advertisement
Table of contents
- 2 IMPORTANT SAFETY INSTRUCTIONS
- 4 UNPACKING
- 5 CAUTION
- 6 FEATURES
- 6 SPECIFICATIONS
- 7 PLACEMENT
- 8 CONNECTIONS
- 9 CONTROLS AND THEIR FUNCTIONS
- 10 AUTOMATIC POWER-SWITCHING FUNCTION
- 11 ADJUSTING THE SUBWOOFER BEFORE USE
- 12 Frequency characteristics
- 13 ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY
- 14 TROUBLESHOOTING