Legacy Locks and Controllers. Schlage AD-Series PIM400, AD-Series WPR400, AD-Series AD-200, AD-Series AD-300, AD-Series AD-250, Legacy CM993, Legacy KC2-9000, Legacy CM5700, Legacy KC2-5500, AD-Series CT5000

Legacy Locks and Controllers

Supported Legacy Locks

KC2

CM

CL

BE367

Supported Controllers

PIM

WRI*

WPR*

WPR2*

WSM*

CT500/1000 Controller

CL Campus Lock Controller

* These devices cannot be configured directly. They are configured through the PIM.

All legacy devices use the serial connection type.

Be sure to change the connection type option when connecting to a

legacy device. See

Connection Type on page 15 for more information.

See Start the

Schlage Utility

Software on page 9

and

Connecting the

Handheld Device on page 11 for more

information.

Program a Lock or Controller

1 Connect the HHD to the lock using the HH-Serial Cable and CIP.

2 Select

Device Options

.

3 Select

Program Lock

.

4 Select the door file that should be associated with the lock.

Î Door files are downloaded to the HHD when synchronized with the access

control software.

5 Select

OK

.

6 Wait for the screen asking for the programming credential. Then present the programming credential to the lock.

Î The lock will flash red and green alternating several times, indicating it has

entered programming mode.

Î Consult the lock user guide that came with your lock for more information

about programming mode.

7 Select

OK

. Lock programming will begin.

Schlage Utility Software User Guide 38