Easy Deploy. HP t5745 Thin Client, t5550 Thin Client, t5740e Thin Client, t820 Flexible Thin Client, t620 Flexible Thin Client, t5570e Thin Client, t5570 Thin Client, t510 Flexible Thin Client, t610 PLUS Flexible Thin Client, t620 PLUS Flexible Thin Client

5 Easy Deploy

NOTE: For Windows Embedded Standard 7, Easy Deploy was replaced by Easy Capture as of version 3.0.1.1725. See

Easy Capture on page 4

for more information.

Easy Deploy enables you to capture an image, deploy an image, and set security. The following tabs are available:

●

Capture—Capture an image, settings, or a configuration.

NOTE: If capturing to a USB flash drive, the USB flash drive capacity must be larger than that of the thin client flash drive. Images larger than 4 GB cannot be captured to a USB flash drive.

●

Deploy—Deploy an image, settings, or a configuration. You can either deploy to the thin client you are using or to another thin client.

●

Security—Set an administrator password to a set of thin clients specified by a list of IP addresses, one per line.

NOTE: You can only deploy the administrator password to thin clients that have the same current password.

5