advertisement
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise bike regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 25 and adjust the contrast level of the display.
If the console does not display your heart rate when you use the handgrip heart rate monitor, see step 5 on page 20.
If the console does not display your heart rate when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter (not shown).
See EXPLODED DRAWING A on page 34. Using a flat screwdriver, gently release the tabs on the Top
Shield (44). Slide the Top Shield upward.
Remove the M4 x 16mm Screw (77) from the Access
Cover (40). Then, remove the Access Cover.
Note: For clarity, the Right Shield is not shown in the drawing below.
Locate the Reed Switch (46). Turn the Right Crank Arm
(23) until a Pulley Magnet (30) is aligned with the Reed
Switch. Next, loosen, but do not remove, the two indicated M4 x 16mm Screws (77). Slide the Reed Switch slightly closer to or away from the Pulley Magnet, and then retighten the Screws.
46
30
23
77
Plug in the power adapter, and turn the Right Crank
Arm (23) for a moment. Repeat these actions until the console displays correct feedback.
When the reed switch is correctly adjusted, unplug the power adapter and reattach the access cover and the top shield. Then, plug in the power adapter.
27
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted.
Loosen the M6 x 20mm Hex Screw (84). Tighten the
M10 x 50mm Hex Screw (83) until the Drive Belt (47) is tight. When the Drive Belt is tight, tighten the M6 x
20mm Hex Screw.
To adjust the drive belt, first unplug the power
adapter (not shown).
See EXPLODED DRAWING B on page 35. Using an adjustable wrench, turn the Left Pedal (22) clockwise and remove it.
47
See EXPLODED DRAWING A on page 34. Using a flat screwdriver, gently release the tabs on the Front
Shield (58) and the Top Shield (44). Remove the Front
Shield and slide the Top Shield upward.
84
83
Remove all the Screws (77, 85) from the Left and Right
Front Shields (13, 14); make sure to note the loca-
tion of each size of Screw.
When the drive belt is correctly adjusted, reattach the left and right shields, the top shield, the front shield, the left pedal disc, and the left pedal. Then, plug in the power adapter.
Using a flat screwdriver, gently release the tabs on the left Shield Disc (52). Rotate the Shield Disc and remove it. Then, gently remove the Left Front
Shield (13).
28
advertisement
Related manuals
advertisement