advertisement
▼
Scroll to page 2
of 81
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
Download
PDF
advertisement
Table of contents
- 5 Apache Labs LLC, Inc. - Declarations of Conformity
- 5 Apache Labs Products CE and RTTE Certified
- 5 Heat Dissipation
- 5 Clarification CCS [60W]/ICAS [200W] operation
- 6 We are very proud of the 8000DLE Design Team
- 6 General Specifications:
- 6 Electrical Specifications:
- 6 Mechanical Specifications:
- 6 Receiver Specifications:
- 7 Transmitter Specifications:
- 7 Audio Connections:
- 7 Additional I/O Connections:
- 7 Ethernet Command and Control:
- 7 Noise Blankers:
- 8 Noise Reduction:
- 8 Minimized Latency:
- 8 Two phase synchronous ADCs
- 8 Front Panel LCD display
- 9 PureSignal Pre-Distortion:
- 9 Ultra-Rugged LDMOS 50vdc
- 11 Introduction
- 11 Minimum Requirements
- 12 Suitable routers or LAN Network switches
- 12 Ethernet Connection
- 13 Simple network setup
- 13 Recommended Software
- 14 ANAN-8000DLE Front Panel
- 15 LCD Front Panel display Power and Self Test
- 15 LCD microcomputer sensors
- 16 ANAN-8000DLE Back Panel
- 17 ANAN-8000DLE back panel Antennas
- 18 ANAN-8000DLE back panel LAN/Phones/Mic/Key
- 19 ANAN-8000DLE back panel XVTR RF1
- 20 Hardware Setup
- 21 Software Setup
- 22 Download the stable release version
- 23 Windows Installation
- 24 Wisdom optimization calculation
- 25 PowerSDR mRX PS Installation Wizard
- 26 PowerSDR mRX PS main window display
- 27 PowerSDR mRX PS Setup Menu
- 28 PowerSDR mRX PS IP address
- 29 PowerSDR mRX PS
- 30 Connecting a suitable Microphone
- 31 MIC Adapters
- 33 Selecting Transmit Profile
- 33 Adjusting mic gain
- 35 Tune
- 35 VOX
- 35 Transmit Filter
- 36 HPF/LPF Filters and switching
- 37 Antenna Control menu allows you to control the following options:
- 38 Sample Rate
- 39 1 Iambic A/B
- 40 Paddle Connection
- 40 CWU/CWL
- 41 Select Operating Frequency
- 41 Set Drive Level
- 42 Break-in Delay
- 43 Sidetone Level
- 44 Antenna
- 44 Note the Antenna Control menu allows you to control the following options:
- 45 Tuning
- 47 Tune/SWR/Output
- 48 PA Drive Level Calibration
- 49 PTT Input
- 49 FET
- 49 How to test your PTT Linear Amplifier circuit BEFORE connecting your Apache Transceiver.
- 49 Various Linear Amplifier Keying ISOLATION adapters are available
- 49 ALC
- 50 Various directional coupler models are available
- 50 VK6PH example OpenCollector BCD keying
- 52 How to Use PureSignal Adaptive Predistortion
- 55 PowerSDR Release github Webpage
- 56 Power SDR Download github version 3.3.11 webpage
- 57 Apache Labs International Support
- 57 Apache Yahoo Support Group
- 57 OpenHPSDR Group
- 57 Apache Service and Repair
- 57 Apache Schematics
- 57 Original 2013 Users Guide
- 58 Balanced Audio Input is not implemented in the current Apache Labs Transceivers.
- 58 Multiple independent .xml databases
- 59 Manual Calibration Procedure
- 60 Computer Performance
- 61 Warranty
- 61 IMPORTANT
- 62 MARS operation
- 62 APIPA Automatic Private IP Addressing
- 63 Apache Labs ANAN-8000DLE PCB (from brochure)
- 64 ANAN-8000DLE PA Filter PCB (from brochure)
- 65 ANAN-8000DLE PA and Filters (from brochure)
- 66 Apache Labs ANAN-8000DLE (from brochure)
- 67 Instructions to load independent versions on a single PC are summarized here:
- 68 Explanation of the bootloader normal operation
- 69 HPSDRBootloader 2.0.4.4 Utility
- 70 If you need a ByteBlaster
- 71 ByteBlaster firmware cabling
- 72 Install Arduino IDE
- 73 Download sketch:
- 73 Open Sketch with Arduino IDE
- 74 Add LCD display library:
- 74 Upload Sketch to 8000DLE
- 75 Start Arduino IDE