USER GUIDE

Connecting AC power

1) Connect one end of the AC power cord to the AC In jack on the back of the monitor.

2) Connect the other end of the AC power cord to an AC outlet.

3) Toggle the power switch to the ON position.

4) Press the power switch. (The LED on the front of the monitor turns on.)

NOTES:

• Your monitor should only be operated from the power source indicated on the label.

• Always unplug the AC power cord from the power outlet when you are not using your monitor for an extended period of time.

External PC touchscreen control setup

1) Connect an external computer to the monitor using a DVI, HDMI, or VGA cable.

2) Connect one end of the USB-A/USB-A cable to the USB-A jack on source computer, connect the other end to

“External Touch” on the front of the monitor.

3) The computer can now be controlled by using touchscreen gestures on the monitor.

TURNING THE MONITOR ON/OFF

1) Verify that the power cord is connected to a power outlet and that the power switch is

ON.

2) Press the Power button on the remote or the right side of the monitor.

NOTE

: By default, the monitor goes into system standby after 30 minutes of inactivity. To change this behavior, use the

Power Save Mode feature in the menu system.

Page 12