Time Zone. araknis AN-500-AP-I-AC, AN-100-AP-I-N, AN-300-AP-I-N

To configure the device to automatically reboot if it fails to ping a gateway, use the Gateway Connection Monitor feature:

1. Enable Gateway Connection Monitor via Settings, Schedule, Gateway Connection Monitor.
2. Set the parameters:
   • Status: Enable.
   • Gateway IP Address: Set this to the IP address to ping.
   • Delay Between Timeouts: Set the interval in seconds to wait before retrying a ping after a timeout. (Default: 30 seconds)
   • Timeout Attempts Before Reboot: Set the number of failed ping attempts before triggering a reboot. (Default: 10)
   • Ping Delay After Auto Reboot: Set the delay in minutes before the device pings again after a reboot. (Default: 15 minutes)
   • Reboot Attempts: Set the number of reboot attempts before the device stops auto-rebooting. (Default: 5)
3. Save and Apply: Click Save, then Apply Changes to enable the settings.

Note: Pinging external addresses can be affected by internet stability, potentially causing false positives.