PDF - Oldcastle BuildingEnvelope

©

MAY 2012

I N S T A L L A T I O N M A N U A L

D O O R A N D F R A M E

INSTALLATION OF OFFSET HUNG DOOR ON PIVOTS

Back-up plates are installed in the door and the frame where required. Frame portion of pivots should be on the frame and door portion of pivots should be installed on the door. The door may or may not be glazed prior to installation of door.

1. Lift door upward and tilt in open position. Place door portion of bottom pivot on frame portion of bottom pivot.

(See illustration)

2. Depress the pivot pin in the door portion of the top pivot.

3. Slide door portion of top pivot under the frame top pivot.

4. Jiggle door until the pivot pin slides into the frame top pivot.

NOTE: To remove door, take the 3 screws out of the frame portion of top pivot and let drop. Then, tip door out of frame.

5. Now that the door is hung, it is time for final adjustments and attachment of hardware.

NOTE: If you have not pre-glazed the door, glaze the door before attachment of hardware.

FRAME TOP

OFFSET

PIVOT

DOOR TOP

OFFSET PIVOT

19

BOTTOM

OFFSET PIVOT

(SEE PAGE 26 FOR ADJUSTMENT)

Phone: 1-866-OLDCASTLE (653-2278)

Web Address: www.oldcastlebe.com