JVC RC-ST3 User Guide Manual

RADIO RECEPTION

Tuning to a station

3

FM MODE/

BEAT CUT RESET

1,2

FM MODE

1,2 3

TUNER TAPE CD

PROGRAM INTRO

FM MODE RANDOM

HBS EQ

VOL

1

Press TUNER to set to the tuner mode.

2 Press TUNER to select the band, FM or AM

(MW).

3

Press and hold

4 or ¢ for about one

second.

The unit starts searching and stops when a station of sufficient signal strength is tuned in.

If you press

4 or ¢ briefly and repeatedly, the frequency changes step by step.

Changing the FM reception mode

When an FM stereo broadcast is hard to receive or noisy, reception may improve by changing to monaural reception mode.

Press FM MODE/BEAT CUT (or FM MODE on the remote control unit).

The MONO indicator lights up in the display window.

To restore stereo reception

Press the button again so that the MONO indicator goes off.

Downloaded From DvDPlayer-Manual.com JVC Manuals

02_01-18_RCST3SL_B_En.p65

12 2/4/03, 2:38 PM

12

Presetting stations

You can preset 20 FM and 12 AM stations.

2 1 3,5 4 4 1 2 3,5

TUNER TAPE CD

PRESET/

REPEAT PROGRAM INTRO

FM MODE RANDOM

HBS EQ VOL

1

Press TUNER to select the band, FM or AM

(MW).

2 Tune to a station you want to preset using

4

or

¢.

3 Press PROGRAM.

4 Press PRESET/REPEAT repeatedly to select a preset number.

The selected preset number flashes.

5

Press PROGRAM.

The station with the preset number is stored in the memory.

6

Repeat steps 2 to 5 to preset other stations, allocating a different preset number to each of them.

Note

If the unit is unplugged or a power failure occurs, the preset stations will be erased from the memory. If this happens, you need to preset the stations again.

Tuning to a preset station

After selecting the band, FM or AM (MW), press PRESET/REPEAT repeatedly until the desired preset number appears.

Adjusting the antennas

FM

02_01-18_RCST3SL_B_En.p65

13

AM

SEARCH UP

STANDBY

SEARCH DOWN

RANDOM

REMOTE

SENSOR

PLAY/PAUSE

INTRO

STOP

RC-ST3

CD PORTABLE SYSTEM

Note

Place the unit away from the TV or turn off the TV, when listening to an AM station, to prevent the built-in ferrite core antenna picking up interference from the TV.

2/4/03, 2:38 PM