advertisement
Setup
Your universal remote requires two (2) AAA
Alkaline batteries (not included).
To Install the Batteries
1. On the back of the remote, push down on the tab and lift the cover off.
2. Match the (+) and (-) marks on the batteries to the
(+) and (-) marks inside the battery compartment, then insert two (2) AAA Alkaline batteries. Be sure to use fresh batteries.
3. Press the battery cover back into place.
NOTE: If your remote stops operating properly, replace the batteries with new ones. The remote will retain the codes you have programmed for up to 10 minutes after the batteries are removed.
Battery Precautions
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Always remove old, weak or worn-out batteries promptly and recycle or dispose of them in accordance with local and national regulations.
Battery Saver
Your remote automatically turns off if the buttons are depressed more than 8 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e.g., between the sofa cushions).
Code Saver
You will have up to 10 minutes to change the batteries in your remote without losing codes you have programmed. However, do not press any buttons until batteries are installed in the remote. If buttons are pressed without batteries in the remote, all codes will be lost.
3
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 Introduction
- 3 Setup
- 3 Battery Installation
- 3 Battery Saver
- 3 Code Saver
- 4 Button Functions
- 6 Programming Your Remote
- 6 Direct Code Entry
- 8 Auto Code Search
- 10 Using Your Remote
- 11 Master Volume Feature
- 12 Code Identification
- 12 Reset to Factory Settings
- 13 Troubleshooting
- 14 Warranty
- 15 FCC Statement
- 16 Introduction
- 17 Configuration
- 17 Installation des piles
- 17 Économiseur de piles
- 17 Sauvegarde des codes
- 18 Fonctions des touches
- 20 Programmation de la télécommande
- 20 Entrée directe de code
- 22 Recherche automatique de code
- 24 Utilisation de la télécommande
- 25 Fonction maîtresse du volume
- 26 Identification des codes
- 26 Réinitialisation aux paramètres du fabricant
- 27 Dépannage
- 28 Garantie
- 29 Déclaration de conformité FCC