advertisement
▼
Scroll to page 2
of
25
$
. EXPLANATION OF THE OPERATION PANEL
Explanation of the respective parts of the operation panel is given below.
For the details of the respective parts, refer to "1. NAME OF EACH SECTION OF THE OPERATION
PANEL" of the Instruction Manual.
1
6
7
8
9
!0
2 3
4
5
1
LCD display section • Touch panel
2
Ready key
3
Information key
4
Communication key
5
Mode key
6
Smart media card slot
7
Slide switch (Not used : OFF)
8
Connector for communication by RS-232C
9
Variable resistor for Color LCD screen contrast regulation
!0
Connector for external input
– 3 –
advertisement
Related manuals
advertisement
Table of contents
- 1 COVER
- 2 CONTENTS
- 3 I. OUTLINE
- 3 II. CONTENTS OF THE ARTICLES PACKED TOGETHER
- 3 1. For those who have purchased the machine provided with IP-200 operation panel
- 3 2. For those who have purchased the single unit of IP-200 operation panel
- 4 III. INSTALLING IP-200 ON TABLE/STAN AND CONTROL BOX
- 4 1. Installing procedure of the operation panel and the installing base
- 4 2. Connecting the cord and turning ON the power
- 5 IV. EXPLANATION OF THE OPERATION PANEL
- 6 V. CONNECTING PROCEDURE OF OPERATION PANEL WITH EXTERNAL VEHICLE
- 6 1. Smart media card
- 8 2. RS-232C
- 9 3. Input of signal by means of the connector for external input
- 10 VI. RE-SETUP OF THE PROGRAM OF THE OPERATION PANEL
- 13 VII. RE-SETUP OF MAIN PROGRAM
- 13 1. When panel program matches with main program
- 16 2. When panel program does not match with main program and an error occurs
- 19 VIII. RE-SETUP OF SERVO PROGRAM
- 19 1. When main program matches with servo program
- 22 2. When panel program does not match with main program and an error occurs
- 25 IX. WHEN USING SMART MEDIA OTHER THAN THAT WHICH HAS BEEN PACKED TOGETHER