advertisement
Chapter 10 W310 Policy Commands
clear-policy-statistics
User level: privileged, supervisor.
Command Mode: Root, PEP/AP Group
Use the clear-policy-statistics command to reset the policy statistics.
Syntax:
The syntax for this command is: clear-policy-statistics [<interface> <direction> [<listtype>]]
Syntax
<interface>
<direction>
[<list-type>]
Description
Resets the policy list(s) for the specified interface.
!
This parameter is required in the Root command mode only.
Resets the statistics by the direction of the policy (to/from interface) or policy list number.
Specify the list type assigned for this choice
Example::
W310-1 (super)# clear policy-statistics
Clearing statistics for:
Interface: floor4 Direction: In List: Default ACL List
Interface: floor4 Direction: In List: Default QoS List
Interface: floor4 Direction: Out List: Default ACL List
Interface: floor4 Direction: Out List: Default QoS List
Avaya W310 Command Reference Guide 181
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 22 Command Abbreviations
- 22 Top and Up commands
- 22 Retstatus command
- 22 Tree command
- 23 Entering the Supervisor Level
- 24 Entering the CLI
- 24 Entering the Technician Level
- 195 Ingress and Egress Policy
- 196 Chapter Contents
- 197 clear-policy-statistics
- 198 composite-operation
- 201 cookie
- 202 cos
- 203 destination-ip
- 204 destination-user-group
- 205 dscp
- 206 dscp-table
- 206 ether-type
- 207 ether-type-rule
- 208 ether-type simulate
- 209 icmp
- 212 ip access-control-list
- 213 ip access-group
- 213 ip-fragments-in
- 214 ip-option-in
- 215 ip policy-list-copy
- 215 ip-protocol
- 217 ip qos-group
- 218 ip qos-list
- 219 ip-rule
- 220 ip simulate
- 222 name
- 223 owner
- 224 pre-classification
- 225 show dscp-table
- 226 show ether-type-rule
- 227 show ip access-control-list
- 228 show ip active-policy-lists
- 230 show ip qos-list
- 231 show ip-rule
- 232 show list
- 233 show-policy-statistics
- 235 source-ip
- 236 source-user-group
- 237 tcp destination-port
- 239 tcp-established
- 240 tcp source-port
- 242 traffic-type
- 243 udp destination-port
- 246 udp source-port
- 248 Network Setup:
- 249 How To Configure
- 251 Network Setup:
- 251 How To Configure:
- 254 Network Setup:
- 254 How To Configure:
- 257 Configuring a QoS Policy for Incoming Traffic:
- 259 Configuring a QoS Policy for Outgoing Traffic