- No category
advertisement
GB IE NI
Assembling instructions
Do not insert the battery until the appliance is fully assembled. Risk of injury!
To put on the protective
cover:
1. Place the protective cover (14) on the motor head (10) and screw it down with the 3 Phillips screws
(14a).
Mounting the trimming unit:
2. Slip the cutting disc (12) onto the axle. There is only one mounting position. Screw the cutting disc
(12) to the axle. Take note: The screw is a left-handed thread and should be turned anti-clockwise to tighten and clockwise to loosen.
Please ensure that the screws
(12a) are properly tightened.
Place the cutting insert (13) on the pin (23) on the cutting disk (12) and pull out the insert until it snaps in.
Spare cutting inserts are kept in the box ( 4) on the auxiliary handle ( 5).
To put on the auxiliary
handle:
3. Pull the ends of the auxiliary handle (5) to extend the handle and slide it over the handle holder
(22). The storage box for your plastic knife (4) must point upwards.
4. Screw down the screw (23) in the auxiliary handle (5).
To insert the battery:
5. To insert the battery (16), place it on the guide track (20) and push it into the appliance. It will audibly snap in.
Operation
Caution: risk of injury! Do not operate the appliance without the protective cover. To operate the appliance, wear suitable clothing, eye and ear protection.
Prior to every use, check that the appliance is operative. Do not block the On/Off switch or the switch lock. They must reliably turn off the motor when you release the switch. Do not operate the appliance if one of the switches is damaged.
Please observe local regulations concerning noise protection.
Turning on and off
Maintain a firm stand and hold the appliance well with both hands and at some distance away from your body.
Before turning on the appliance, check that it will not touch any objects.
1. Check that the battery (16) is in
(see “Assembly instructions - Inserting the battery”).
2. To turn on, use your thumb to actuate the switch lock (3), then press the On/Off switch (2). Release the switch lock.
3. To turn off, release the On/Off switch (2). There is no continuous operation mode.
15
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 Introduction
- 4 Intended purpose
- 5 General description
- 5 Extent of the delivery
- 5 Overview
- 5 Functional description
- 6 Technical data
- 6 Safety instructions
- 7 Symbols and icons
- 8 for power tools
- 12 Further safety directions
- 12 Residual risks
- 13 of the battery charger
- 13 Charging the battery
- 14 Removing/inserting the battery
- 14 Recharging the battery
- 14 Used batteries
- 15 Assembling instructions
- 15 Operation
- 15 Turning on and off
- 16 Checking the battery charge level
- 16 Trimmer settings
- 16 Manner of operation
- 17 Cutting grass
- 17 trimming
- 17 Cleaning and maintenance
- 17 Cleaning
- 18 General maintenance
- 18 Replacing the cutting insert
- 18 Storage
- 18 of the environment
- 19 Trouble shooting
- 20 Guarantee
- 21 Repair Service
- 21 Service-Center
- 21 Importer
- 42 EC declaration of conformity
- 45 Exploded Drawing
- 22 Einleitung
- 22 Verwendung
- 23 Allgemeine Beschreibung
- 23 Lieferumfang
- 23 Funktionsbeschreibung
- 23 Übersicht
- 24 Technische Daten
- 24 Sicherheitshinweise
- 25 Symbole und Bildzeichen
- 26 für Elektrowerkzeuge
- 31 Sicherheitshinweise
- 31 Restrisiken
- 32 mit dem Akkuladegerät
- 33 Ladevorgang
- 33 Akku entnehmen/einsetzen
- 34 Akku aufladen
- 34 Verbrauchte Akkus
- 34 Montageanleitung
- 35 Bedienung
- 35 Ein- und Ausschalten
- 35 Ladezustand des Akkus prüfen
- 36 Einstellungen am Gerät
- 36 Arbeitshinweise
- 37 Gras schneiden
- 37 Rasenkantentrimmen
- 37 Reinigung und Wartung
- 37 Reinigung
- 38 Allgemeine Wartungsarbeiten
- 38 Kunststoff-Messer auswechseln
- 38 Lagerung
- 38 Entsorgung/Umweltschutz
- 39 Garantie
- 40 Reparatur-Service
- 40 Service-Center
- 40 Importeur
- 41 Fehlersuche
- 41 Ersatzteile/Zubehör
- 43 erklärung
- 45 Explosionszeichnung