Pockets limit. Dors 800

Figure 6

8

5

7

9

Figure 7

10

11

7 Contact image sensor

8 UV reflection sensors

9 Magnetic sensors

Preparing for Operation

10 Counting sensors

11 Diverter

1 Make sure that the safety precautions mentioned in the relevant section of

the manual are kept.

2 Install the banknote guide (Fig. 1, item 2) included in the delivery set:

2.1 Take one banknote guide (Fig. 1, item 2) and match the tabs of the

guide ( see Fig. 8) with the slots of the banknote guide holder (see

Fig. 9).

2.2 Push the guide into the holder (see Fig. 10).

2.3 To fasten the guide on the holder, move it down up to the stop (see

Fig. 11).

2.4

Repeat points

2.1-2.3

for the second banknote guide.

2.5 T o check that the banknote guides are installed properly, move the

guides manually aside, to the maximum and minimum; the

movement shall be synchronous and without jerks.

To remove the guide (for example, before transportation), take the upper part of the guide, press it slightly and then pull it up.

Banknote guide holder

Figure 8

Tabs

8

Clamps

Slots

Figure 9

DORS 800 BANKNOTE SORTER

Figure 10 Figure 11

3. Connect the sorter to electric outlet by power cord.

Operation

1 Make sure that the safety precautions mentioned in the relevant section of

the manual are kept.

2 Use a power switch (Fig. 2, item 12) to switch the sorter on. After you

have done it, a process of the firmware loading and self-testing is activated

and an image (

see Fig. 12) appears on the graphical display (Fig. 3, item

2). During self-test the loading indicator is moving, the stacker wheels

( Fig. 1, item 8) and the hopper rollers (Fig. 1, item 3) are rotating.

Figure 12

SW version

Currency database version

Loading indicator

After self-testing is over, you hear an audio signal, and the display shows the following picture (

see Fig. 13):

DORS 800 BANKNOTE SORTER 9