First time Auto Setup. Panasonic TXP55VT65B, TXP50VT65B, TXP65VT65B

18

First time Auto Setup

Automatically sets up the TV and searches for available TV channels when the TV is turned on for the first time.

●

These steps are not necessary if the setup has been completed by your local dealer.

● Please complete connections (p. 8 - 13) and settings (if necessary) of the connected equipment before starting Auto

Setup. For details of settings for the connected equipment, read the manual of the equipment.

1

Plug the TV into mains socket and turn power on

● Takes a few seconds to be displayed.

2

Select the following items

Set up each item by following the on-screen instructions.

Select [Home]

Select [Home] viewing environment to use in your home environment.

● [Shop] is for shop display.

● To change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.

Set up the network connection

Select your country

●

Auto Setup screen varies depending on the country and the signal mode.

●

[Satellite Antenna Setup]

Ensure the satellite connections are completed (p. 9) and select the tuner mode ([Dual Tuner] / [Single Tuner]).

Select your region

Register the VIERA Touch Pad Controller to this TV

Select [Pairing] and follow the on-screen instructions to use the touch pad controller (supplied).

Register the Electronic Touch Pen to this TV

Select [Pairing] and follow the on-screen instructions to use the Electronic Touch Pen (supplied).

3

Select the type of [Home Screen]

The demonstration to explain how to use [my Home Screen] is displayed. Confirm the demonstration by following the on-screen instructions, and then select the desired [Home Screen].

Example: [Home Screen Selection] Example: [TV Home Screen]

● [my Home Screen] is the start-up screen when the TV is turned on or the HOME button is pressed.

Auto Setup is now complete and your TV is ready for viewing.

If tuning has failed, check the connection of the network, Satellite cable, RF cable, and then follow the on-screen instructions.

Note

●

The TV will automatically go into Standby mode when no operation is performed for 4 hours if [Auto Standby] in the

Timer Menu is set to [On].

● The TV will automatically go into Standby mode when no signal is received and no operation is performed for

10 minutes if [No signal Power off] in the Timer Menu is set to [On].

● To retune all channels [Auto Setup] in [Tuning Menu] (Setup Menu)

● To initialise all settings [Shipping Condition] in [System Menu] (Setup Menu)