Virtual Server Settings Example. NetIQ 4.2

Virtual Server Settings Example

After setting up the real server settings, you need to configure the virtual server settings. The following is an example from a Foundry switch.

Setting up L4 Switch for IPv6 Support

IPv6 provides large number of available addresses, increased security, and reliability. For supporting

IPv6, the L4 switch must support addressing both IPv4 and IPv6 as seen in the following figure.

There is no change in listener configuration for Access Manager devices. Hence, real IP configuration and real server group configuration in L4 switch remain the same. Change is required only in the virtual server configuration to accept IPv6 connections.

Figure 8-2

L4 Switch Support For Both IPv4/IPv6

IPv4/IPv6

Firewall 1

Clustered

Identity Servers

IPv4

Firewall 2

LDAP

User Stores

L4 Switch

IPv4/IPv6

Clients

Clustered

Access Gateways

DMZ

The existing IPv4 virtual server configuration is as follows: server virtual vir-ipv4 10.50.50.1

predictor round-robin port 8080

Web Servers

Administration

Consoles

High Availability and Fault Tolerance

779