Platinum™ SX Pro Multiviewer
Installation and Operation Manual
Appendix B
Servicing Instructions
Appendix B
Servicing Instructions
CAUTION
These servicing instructions are for use by qualified personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
When servicing your Platinum SX Pro system, ensure that you take precautions to prevent electrostatic discharge (ESD). See "Appendix A: Safety Precautions, Certifications, and Compliances" in your Platinum
Installation, Configuration, and Operation Manual for more information.
These servicing instructions contain the following information:
• Replacing a Fan (on page 232 )
Replacing a Fan
In the event that one of the fan units fails in a Platinum SX Pro module, you should install a replacement as soon as possible to prevent overheating. Replacement fans are available from Customer Service.
To replace a failed fan unit, follow these steps:
1. Open the front door of the Platinum frame and remove the module or complete set of two or four
Platinum SX Pro output modules.
It is not necessary to remove power from the frame to remove the modules.
2. If necessary, separate the modules so the top of the module that has experienced the failure can be accessed.
3. Identify the fan you are replacing, and then remove the corresponding header wires from the PCB board .
4. Unscrew the fan, and then pull it firmly away from the assembly to remove it from the standoffs.
© 2016 Imagine Communications Corp. Proprietary and Confidential. Software Version 5.5 | Page 232
Platinum™ SX Pro Multiviewer
Installation and Operation Manual
Appendix B
Servicing Instructions
5. Position a new fan over the assembly standoffs, and then fasten the fan into place with the supplied screws.
(Ensure that the fan labeling is face down, and that the header wiring is aligned correctly, as shown above.)
Do not over tighten the screws.
6. Connect each new fan’s header wires to the assembly PCB board.
7. Reconnect the Platinum SX Pro modules together in a stack.
8. Reinsert the Platinum SX Pro module set into the frame, ensuring that the alignment pin merges with the back module and the modules fit smoothly within the module guides in the frame.
9. Close the Platinum frame front panel.
© 2016 Imagine Communications Corp. Proprietary and Confidential. Software Version 5.5 | Page 233
