DayMark 9700 Training Manual Click Here

micro sD carD UpDate iNstrUctioNs

4. operatiNg system maNagemeNt

tFtp UpDatiNg NetWork settiNgs iNFormatioN

The 9700 has the ability to connect to an IP network using a standard LAN cable. To configure network parameters on the 9700 the manager needs to follow the steps listed below.

1. Click on the SETTINGS button, enter an appropriate password and click on “System

Preferences” to display the system settings screen.

1. Turn off the DayMark 9700.

2. Pull down the access door on the right hand side of the screen.

2.

3. Remove the existing Micro SD Card located in the middle port. Use caution as the

SD card port is spring loaded.

4. Copy new system files to Micro SD Card.

5. Install the Micro SD Card gold contacts facing front of the unit. Be sure to insert the SD

Card into the card port and not into the gap between the printer and the port. Inserted

correctly .

into the card port, the SD Card will meet a slight spring resistance and need to

be pushed in until locked.

2. Click on the NETWORK button to display the NETWORK SETTINGS screen.

The NETWORK SETTINGS screen provides for two modes of network configuration,

Dynamic Host Configuration Protocol (DHCP) or static IP.

3.

6. Power on the DayMark 9700.

3. The static IP mode is shown below. There are fields provided to enter the IP Address,

Subnet Mask and Gateway address values.

51.