advertisement
PLACEMENT OF VFSUE CONTROL MODULE
The control module is packaged under the burner at the manufacturer. Use caution to keep all the wire connections in place when removing the burner and module from the carton.
During appliance installation, place the control module on the pilot side of the burner, but
not under the burner.
PILOT
SHIELD
CONTROL
MODULE
Figure 9
Insert 4 AA batteries into the control module. Follow the directions on pages 24 to 27 to sync the remote and control module.
After the appliance has been installed, slide the control module shield over the control module. Place the module in a location that is easy to reach so that the batteries can be changed.
The control module must remain on the fireplace floor or firebox bottom. This location will keep the batteries cool and result in a longer battery life.
PILOT
CONTROL
MODULE
Figure 10
Notice: Lava rock can be used to hide the control module and shield.
31722-6-0616 Page 15
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project