NEC ESMPRO Manager Ver.5 Installation Guide (Linux)
2.3 Managed server
This section explains conditions for servers to be managed by the NEC ESMPRO Manager.
Hardware
-- The server that integrates a standard BMC conforming to IPMI Ver.1.5 or Ver.2.0.
-- The server that integrates EXPRESSSCOPE Engine or EXPRESSSCOPE Engine 2 conforming to
IPMI Ver.2.0.
-- The server that is installed a Remote Management Card [N8115-01CP01] conforming to IPMI
Ver.1.5 or Ver.2.0.
-- The server that is installed an Advanced Remote Management Card [N8115-02CP01] conforming to
IPMI Ver.2.0.
CHECK:
The monitor function by the SNMP does not support it. NEC ESMPRO Manager will not be managed as the result of the install. See the “Appendix C. Managed Servers Summary” of the “NEC ESMPRO Manager Ver.5 Setup Guide”.
The required environment varies depending on the connection type with the managed
server. See 2.4”Requirements for Connection between the NEC ESMPRO Manager Server and Managed Server”.
TIPS:
EXPRESSSCOPE Engine and EXPRESSSCOPE Engine 2 are generically called
EXPRESSSCOPE Engine series.
Software
-- You cannot use the monitoring function by the SNMP even if you install NEC ESMPRO Agent.
15
NEC ESMPRO Manager Ver.5 Installation Guide (Linux)
2.4 Requirements for Connection between the NEC ESMPRO
Manager Server and Managed Server
LAN connection
TCP/IP network
LAN port
-- LAN port that BMC uses depends on the type of BMC. Some BMC uses standard LAN port. Other
BMC uses an exclusive LAN port (Management LAN Port). See the “Appendix C. Managed Servers
Summary” of the “NEC ESMPRO Manager Ver.5 Setup Guide”.
-- There are 2 types of managed servers that BMC uses standard LAN port: one type is permitted to use only LAN1 port, and the other type is permitted to use both LAN1 and LAN2 ports. See the
“Appendix C. Managed Servers Summary” of the “NEC ESMPRO Manager Ver.5 Setup Guide”.
16
