Windsor PV5 Instruction Manuals

POSSIBLE CAUSE SOLUTION PROBLEM

ELECTRICAL WARNING: When using for wet pickup No power to machine Dead electrical circuit Check building circuit breaker or fuse box.

The Model PV5 Wet/Dry Vacuum

Cleaner operates on standard 15 amp, an overflow of water or dirt into the vacuum motors can cause them to fail!!

Constantly monitor the level of waste

Power switch failure. Replace.

120volt A.C. household current 220 volt

Faulty electrical cable. Replace. water in the recovery bucket. When about 2/3rds full, shut off the machine, remove the dome, take out bucket and

Electrical shock Equipment not grounded. Ground prong on plug broken option available. Voltages below 105 volts, or above 125 volts, will cause potentially serious damage to the vac off. Never operate machine with grounding prong removed. motors. empty. Keep the exterior of the bucket dry so no moisture gets into the vacuum

Thirty-five feet of 16/3 STJO cable with a 3-prong plug is the power connection

Motor speed varies or doesn’t run

Motor brushes worn.

Motor worn out.

Replace.

Replace. chamber. Replace the bucket, center and seal the dome and continue

Loss of vacuum Loose vacuum dome. Center and seal dome over tank. to the machine. cleaning.

This system has 3 main units:

Clogged water chamber. Rinse out with water.

1. Cabinet assembly with vacuum motors, and attached electrical cable.

Do not use to pick up volatile materials or dry chemicals. Do not expose the unit to rain. Always store it indoors.

Crack in dome or defective glue joint.

Replace or reseal using acrylic plastic cement only.

With power off, clean screen. Do not tip over the machine. Always Lint or dirt clogging vacuum screen.

2. Dome and perk/filter chamber and cage. operate with vac hose clipped by rope leash to the machine. Loose cuffs on vacuum hose. Tighten cuffs turning counter- clockwise.

3. Waste bucket. AFTER CLEANING

Vacuum motor seals leaking. Replace.

Carefully unpack and inspect all com- ponents for shipping damage. If you discover any damage, notify the deliver-

Empty the waste water bucket and rinse it thoroughly. Wipe out tank. Wipe off

Floor tool vacuum chamber plugged.

Wash out with hose. Pick lint out with wire machine and wand with a damp cloth.

Clean lint from the two air screens

Broken vac hose. Replace. ing carrier immediately. Your machine was tested and inspected thoroughly before shipment, and damage is the re-

Damaged dome gasket. Replace. inside the vacuum chamber before each use. Worn out vac motor. Replace. sponsibility of the carrier.

MAINTENANCE

OPERATION

Attach vacuum hose between the wand and floor tool and the machine.

Periodically inspect the surfaces, hoses, cable, filters and connections on your machine. All surfaces should be clean to minimize abrasion damage. Use only

I

FOR DRY PICKUP

The waste bucket MUST have at least soap and water for cleaning your

LIMITED WARRANTY

5” of water in it before dry pickup is machine. Do not walk on hoses. Keep them clean and unkinked. Frayed spots

WINDSOR warrants to the original purchaserluser that this product is free from defects in workmanship and workmanship during normal service and usage except for transportation costs started, and the perk/filter chamber on hoses should be covered and end and cage must be in place. materials under normal use and service for a period of one year from date of purchase WINDSOR will. at its

This limited warranty is in lieu of all other warranties expressed or implied and releases WINDSOR from all connectors kept snug. Because the option. repair or replace without charge, except lor

FOR WET PICKUP transportation costs. parts that fail under normal use and service when operated and maintained i n other obligations and liabilities It is applicable only in the U S A and Canada and is extended only to the electrical cable will lie on W e t carpet or original userlpurchaser of this’product WINDSOR is

Wet pickup should be done with the floors at times, the cable must be well accordance with the appl!cable operation and InStrUC- tion manuals This warranty does not apply to normal wear, or to items whose life IS dependent on their use not responsible lor costs for repairs performed by persons other than those specifically authorized by

WINDSOR This warranty does not apply to damage perk/filter chamber and cage in place. insulated and cable connector screws and care, such as cords. switches. hoses. rubber parts. should be tight. Do not walk on the electric motor parts. etc from transportation alterations by unauthorized persons misuse or abuse of the equipment use of non Insert electrical plug into 115 volt, 15 cable or run machinery over it. If the compatible chemicals or damage to property or loss of amp outlet. Make sure the dome is in IN ADDITION to the above warranty. for a period of

5 YEARS WINDSOR will. without charge. either re- income due to malfunctioning of the product place and sealed. You may be working cable insulation is broken or frayed,

If a difficulty develops with this machine you should repair or replace it immediately. Don’t place or return to working order. at its option. any solu- tion tank that fails as a result 01 defects in materials or contact the dealer from whom it was purchased on wet cerpet or wet floors, so make sure the machine is properly grounded.

To prevent an overloaded circuit, do not operate on the same circuit with other take chances with an electrical fire or shock.

If necessary, the plastic perk/filter

WINDSOR INDUSTRIES, INC.

2635 CO 80223 chamber can be removed for cleaning appliances.

Turn power switch ON. by releasing the rod that holds it in place. When replacing the chamber be To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com

place.

303’777-7774

ASSEMBLE

ASS-LE-

=

PERK/FILTER VAC MACHINE BREAKDOWN AND PARTS LISTING

U

,

& 6 v

J

I w

-_bJ__.

.

,...

,.

_. .

ED

_ _ x

-.

17

18

19

20

8

9

10

11

12

13

14

14A

15

16

1

1

2

2

2

2

2

1

1

1

2

4

4

1

1

1

1

1

1

1

KEY AMT. PART NO.

2

3

4

5 . r

-

7

DESCRIPTION

-

Base-PV-5

72-003 Tank Cabinet A S S

- PV-5

10-159MCHD TankTopABS

10-162 Perk/Filter Chamber PV-5

10-168 Dome, PV-5

20-128

21-027

22-026

22-025

21-072

21-081

50-024

50-005

25-051

25-001

30-001

30-002

30-046

Electric Cord 16-3x35'

Cord Cap 120V - 3-Wire

Lead Assy. Switch PV-5

Lead Assy. Vacuum Motor

Rocker Switch

Strain Relief w/Spring

Vacuum Motor Gasket 7.5"

Dia.

Gasketseal.

V a c M o t o r - l / E x l l / l G

Vacuum Motor 12OV

Vacuum Motor, Tangential 220V PV-5

Wheel, 6 ~ 1 %

Caster, 3 x 1 Vi

Screen -Vacuum Intake 1% Dia.

33-010

33-015

Hexnut Vi - 20

Bolt. Vi - 20 x 2. I-Bolt

55

57

~~

58

1

1

06-004

06-009

Squeegee Shoe for 106-003

Carpet Shoe for 106-003

Master Floor Tool Head

Upholstery Twl PV-5

PERK/FILTER VAC

WIRING SCHEMATIC

VACUUM MOTORS

<J

R OCKER swim

6 MONTHS

HOURS

O R 750 OPERATING

Removing Waste Water Cabinet As- sembly From Base:

1. Disconnect machine from power source.

2. Remove the handle

3. Turn machine upside down and remove the two lock nuts from the bolts coming through the casters

(one on each caster).

4. Remove base from cabinet and disconnect leads at the molex connector.

VACUUM MOTOR

1. To remove vac motors, disconnect wires and remove three 1/" hex- nuts.

2. Lift out vac motors being careful not to damage seals

3. To inspect brushes: remove brush holddowns. New brush length is 1". Brushes should be replaced when they reach 318" length or after 750 operating hours.

4. Inspect vacuum intake opening for lint. If there are large accum- ulations, the fan section should be disassembled and cleaned. Note:

Vacuum motors can usually be repaired, but such repairs should always be done by a qualified vacuum repair shop.

PRODUCT MODIFICATION

-

Dome Assembly-Perk/Filter

Vac

Your new Perk/Filter Vac is equipped with newly designed dome and hose assemblies. This notice should be retained with your Dealer Manual for reference when ordering replace- ment parts in the future.

NOTE:

Part

#lo-168

-

PV-5 includes both sub assemblies individual parts or assemblies can be ordered as shown on parts list.

I

2

I n

7

6

I

I

I DOME ASSEMBLY

I I

KEY PART NO. DESCRIPTION

I

1

1

10-168 Dome/Hose Adapter Assy

28407 Dome

2 57407 Nut, 1 YZ " Flange

3 86401 Hose Adapter

-

PV-5

I

I

W

To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com

13 87-009 Taa Alona Cord Assv. PV-5

W1982