Setting Up the DVR Unit. Avermedia AVerDiGi

1.5

Setting Up the DVR Unit

1.5.1 Installing the Hard Disk

i - For hard disk spec, please referring to http://www.avermedia.com/AVerDiGi/Product/ → Pure DVR

→ AVerDiGi EXR6004 Mini → Hardware Recommendations

- The DVR unit may include hard disk that depends on the model user has purchased. If the model user has purchased is included hard disk, user doesn’t need to install the hard disk by yourself.

The “compatible hard disks” indicated in the above recommendation list only means that these commercially available hard disks were tested with AVerMedia products and functioned well under normal operation conditions. AVerMedia does not guarantee or provide warranties, explicitly, implied or statutory with respect to the reliability of the hard disk function or its compatibility. In no event

AVerMedia shall be liable for damages, with respect to any business interruption of clients, lost profits, loss of programs or other data on your information handling system or otherwise. This includes direct, indirect, incidental, special, or consequential damages, resulting from the incompatibility caused by the usage of these hard disks, even if AVerMedia has expressly advised about the risk of such damages.

The entire risk arising out of the use of any information attached here with is borne by the recipient.

The DVR unit allows user to install one hard disk. Follow the illustrated instructions below to install the hard disk:

2. Push the cover backward and lift

3. Secure the brackets on the hard disk 4. Connect the the SATA cable and the power connector to the hard disk

5

5. Secure the hard disk inside the unit then place unit cover

6. Push the cover forward and secure the cover

7. You may now connect all the cables. When the power is connected, the Power LED light turns on

6

The back panel of the DVR unit, user can connect the 4 sensor devices, 1 alarm device, audio input/output device and an external HDD storage device. Through the two Gigabit LAN ports can connect with the IP cameras and allows user to remote access the DVR server. The USB ports can connect the mouse and keyboard for more easily to operate DVR server.

Follow the illustration below to make the connection:

7

1.5.3 Connecting the Audio, Sensor and Relay device

The Sensor, Alarm, and audio port enable you to connect 4 sensor inputs, 1 relay outputs, and 1 audio in and 1 audio out device. Just connect the external sensor, relay, and audio in/out device pin directly to the pinhole.

Check the table below and locate which pinhole is assigned to sensor input, relay output, and audio in/out.

The signal from the sensor (i.e., infrared sensors, smoke detectors, proximity sensors, door sensors, etc.) is being transmitted to the unit and this triggers the system to respond and send signal to relay device (i.e., alarm, telephone etc).

Audio in and out pinhole:

Pin #

1

2

3

4

Definition

Audio input signal

Audio Ground signal

Audio output signal

Audio Ground signal

Sensor and Alarm pinhole:

10

11

12

13

14

Pin #

5

6

7

8

9

Definition

Sensor 1 signal

Sensor 1 Ground signal

Sensor 2 signal

Sensor 2 Ground signal

Sensor 3 signal

Sensor 3 Ground signal

Sensor 4 signal

Sensor 4 Ground signal

Relay signal

Relay signal

8