CHORUS DEPTH. Yamaha Portatone PSR-4000, PSR-4000

112

F5: Reverb/Chorus/DSP Effect

■

CHORUS DEPTH

..........................................................................................................................................................................

Independently sets the depth of the chorus effect for the multi pads, accompaniment, left voice, right

1 voice, right 2 voice, and lead voice

Use the M.PAD, ACMP, LEFT, R1, R2, and

LEAD LCD [▲/▼] controls to set the depth of the chorus effect as required for the corresponding parts.

The depth range is from “0” (no chorus effect) to

“100” (maximum chorus depth).

NOTES

• In addition to the graphic depth controls directly above the

LCD [ ▲ / ▼ ] controls, the chorus depth for each part is represented by a vertical bar to the right of the CHORUS

DEPTH parameter in the upper section of the display. The longer the bar, the greater the chorus depth.

• When a new style is selected, the preset chorus type and depth value for that style is automatically recalled.

• Each part and voice has a preset depth value and range over which the depth can be varied. Depth variations may therefore not have the same audible effect with all voices.

■

DSP EFFECT TYPE & DEPTH

........................................................................................................................................

●

DSP EFFECT TYPE

Selects the effect to be applied when the [DSP

EFFECT] button is turned on (page 34).

If the DSP EFECT TYPE parameters are not showing on the lower section of the display, press the TYPE LCD button. Use the LCD [▲/▼] controls to select the desired type. The name of the current

DSP effect type is shown to the right of the DSP

EFFECT parameter in the upper section of the display. See “THE DSP EFFECTS AND PARAM-

ETERS”, below for a list of the effects and their parameters.