5.3 USB Firmware Updating. PTN MHD44TP

HDBaseT Matrix Switchers 4x4

EDIDM[X]B[Y].

EDIDUpgrade[x]

.

Manually EDID switching. Copy the EDID data of output[X] to the input[Y].

Upgrade EDID data via the RS232 port

[X] is for input port, when the value of X is 5, it means to upgrade to all input ports. When the switcher gets the command, it will show a message to send EDID file (.bin file).

Operations will be canceled after 10 seconds.

(Note 1)

Note:

1. Please disconnect all the HDBaseT cables before sending command

EDIDUpgrade[X].

2. In above commands, “[”and “]” are symbols for easy reading and do not need to be typed in actual operation.

3. Please remember to end the commands with the ending symbols “.” and “;”.

4. Type the command carefully, it is case-sensitive.

5.3 USB Firmware Updating

To meet with the request of different users or add function in future, the firmware of MV4 can be upgraded via USB. When you need to upgrade it, please download the latest upgrade file and then you are able to upgrade it through the update EXE software. Copy the EXE software to the PC in controlled and double chick the program to upgrade the firmware.

Figure 7 Update EXE Software

When the program is running normally, it will enter in to the interface (as shown in next figure), please press the button and choose the upgrade file downloaded, and then press the button . It is ready to upgrade. When all are done, it will appear with a window shows the message Update success.

PTN Electronics Limited 12 www.PTN-electronics.com