Certification and compliances. Alpha Novus FXM 1100

Product Safety Information

■ Never dispose of batteries in a fire. The batteries may explode.

Follow the manufacturer’s directions and check with your local jurisdictions for safe battery disposal.

Caution: You must read and understand the following cautions before installing the Novus FXM and its components. Failure to do so could result in equipment damage.

■ Before attaching the batteries to the FXM, make sure the polarity is correct.

■ If the batteries have been in storage for more than 3 months, recharge them for at least 24 hours then test them with a load before installation.

■ Each AlphaCell™ battery has a date code, found on the warning label, which must be recorded in the maintenance log. If non-Alpha batteries are used, see the manufacturer’s documentation for date code type and placement.

Certifications and Compliances

■ The Novus FXM has been designed, manufactured, and tested to the requirements of the following national and international safety standards:

; CAN/ CSA-C22.2 No. 107.3 – Uninterruptible Power Systems

; UL 1778 (Edition 4) – Uninterruptible Power Systems

; FCC CFR47 Part 15 Class A – This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense..

Doc# 017-201-B0 Rev 0408 7

This page is intentionally left blank.