- Industrial & lab equipment
- Electrical equipment & supplies
- Power conditioning
- Power supply units
- Alpha
- Novus FXM 1100
- User manual
advertisement
Installation
ATS/GTS Option
The ATS (automatic transfer switch) and the GTS (generator transfer switch) are two separate optional add-on switching units for the FXM family (FXM 650, 1100 and 2000). The ATS provides power and/or bypass capacity (automatic or manual) so the operator may disconnect the FXM family of products from line power for easy removal and servicing. In bypass mode, the loads are directly connected to the line power without any conditioning. The ATS and GTS can be used alone or together to allow the use of 3 different back-up sources (line, batteries and or generator). Refer to the ATS/GTS Installation
Manual (Alpha P/N 020-161-B0) for details.
WARNING
Make sure you have read and understood the instructions given in the ATS/GTS Installation Manual before making any connection to the supply.
Installation and wiring instructions are provided on a separate installation manual (020-161-B0).
Doc# 017-201-B0 Rev 0408 31
This page is intentionally left blank.
7. Operation
The following sections describe the operation of the Novus FXM.
■ Operating the control panel on page 34.
■ Turning the FXM On and Off on page 37.
■ Replacing the batteries on page 83.
■ Operating the Novus FXM on page 40.
■ Making measurements on page 42.
■ Viewing the 25-event log on page 43.
■ Communicating with the RS-232 interface on page 44.
Doc# 017-201-B0 Rev 0408 33
advertisement
Related manuals
advertisement
Table of contents
- 5 General warnings and cautions
- 7 Certification and compliances
- 9 What this manual covers
- 10 Who should read this manual
- 10 How to use this manual
- 10 Symbols used in this manual
- 11 Symbols used on the product
- 11 Related documents
- 13 Introduction
- 14 Front panel description
- 21 Safety precautions
- 22 Electromagnetic compatibility (EMC) requirements
- 23 Opening the package
- 23 Checking the package contents
- 25 Tools and equipment required for installation
- 26 Mounting the Novus FXM
- 28 Wiring the external batteries
- 30 Wiring the Novus FXM
- 31 ATS/GTS option
- 34 Operating the control panel
- 37 Turning the Novus FXM on and off
- 39 Replacing the batteries
- 40 Operating the Novus FXM
- 42 Making measurements
- 43 Viewing the 25-event log
- 44 Communicating with the RS-232 interface
- 45 Wiring the RS-232 port
- 46 Using the main menu
- 50 Adjusting and controlling the Novus FXM
- 51 Programming the dry contacts and the clock
- 54 100-Event Log
- 56 Novus User Software
- 79 Updating the software
- 82 Testing and replacing the batteries
- 85 Preventative maintenance
- 86 Service and technical support