Quick Start. Metrologic Hand-Held Scanner

4

Quick Start

1.) Plug in the scanner. When the MS951 is ready to scan, the red LED will turn on, followed by the green LED, and then the scanner will emit one beep.

2.) The scanner is shipped from the factory programmed with default settings. To configure the MS951 scanner to meet the host system’s specific needs, refer to the Programming

Guide (MLPN 2366) for instructions on how to enter the program mode and to select the appropriate bar codes.

Note: Keyboard Wedge scanners default to Keyboard Wedge

Communications and USA, AT keyboard when the Recall

Defaults is scanned. With all other versions, the Recalll Defaults barcode configures the MS951 for an RS-232 interface. If RS-232 is not being used, scan at least one other bar code to enable OCIA,

Light Pen or 46xx.