ASSEMBLY. ProForm 425 PCTL93070, PCTL93070

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires two adjustable wrenches and a phillips screwdriver (not included).

1. Attach two Base Pads (57) to the bottom of the Base

(59) in the indicated locations. Note: One extra Base Pad is included.

1

57

59

57

2. Firmly hold the left or right handrail as shown. Raise the handrails until the Base (59) and the front Wheels (56) are resting on the floor.

Remove the six Weight Rack Screws (106) and the metal plate (not shown) from the right side of the Base

(59). Discard the metal plate.

Attach a Weight Rack (110) to the right side of the Base

(59) with the six Weight Rack Screws (106).

Attach the other Weight Rack (110) to the left side of the

Base (59) in the same manner (not shown).

3. Make sure that there is a Frame Guide (52) on the left side of the Frame (23). If there is not, attach the Frame

Guide with two screws (100) as shown. Make sure that the thick end of the Frame Guide is at the bottom.

2

3

Handrails

59

100

52

Thick end

23

56

4. Next, the treadmill should be raised to the storage position. Hold the treadmill with your hands in the locations shown at the right. To decrease the possibility of in- jury, bend your legs and keep your back straight. As you raise the treadmill, make sure to lift with your

legs rather than your back. Raise the treadmill about halfway to the vertical position.

4

59

110

106

106

106

5

5. Move your right hand to the position shown at the right, and hold the treadmill firmly. Raise the treadmill until the

Storage Latch (50) closes over the Frame Guide (52)

(see the inset drawing). Make sure that the Storage

Latch closes fully over the Frame Guide.

5

6. Slide the Stabilizer Pad (63) onto the bottom of the

Stabilizer (64) in the indicated location.

Attach the Stabilizer (64) to the Base (59) with two

Stabilizer Bolts (62) and two Stabilizer Nuts (61) as shown.

Before moving the treadmill, see HOW TO MOVE THE

TREADMILL on page 11.

6

7. Refer to assembly drawing 5 at the top of this page.

Hold the upper end of the treadmill with your right hand as shown. Using your left thumb, slide the Storage Latch

(50) to the left. Pivot the treadmill slightly until the Frame

Guide (52) is past the Storage Latch.

Hold the treadmill with both hands in the locations shown at the right. Lower the treadmill to the floor. To decrease the possibility of injury, bend your legs and keep your back straight.

7

61

62

52

50

Closed

59

62

64

63

8. To attach the Book Rack (4) to the Console (2), first remove the backing from the Tape (60). Align the holes in the Book Rack with those in the Console. Attach the

Book Rack to the Console with the four Screws (100) as shown.

8

60

100

4

9. Remove the backing from the Adhesive Clip (77). Press the Adhesive Clip onto the Rear Roller Cover (78) in the indicated location. Press the Allen Wrench (76) into the

Adhesive Clip.

10.Make sure that all parts are tightened before you use the treadmill. Note: To protect the floor or carpet, place a mat under the treadmill.

6

9

2

78

76

77

100