Common Operations. JVC SP-MXK50, MX-K50

Common Operations

Turning On or Off the Power

To turn on the unit, press STANDBY/

ON so that the STANDBY lamp goes off.

STANDBY

STANDBY/ON

3

Press

4 or ¢ to adjust the minute, then press SET.

SET

STANDBY

To turn off the unit (on standby), press

STANDBY/ON again so that the

STANDBY lamp lights up.

STANDBY/ON

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –” soon, while the tuner preset stations

(see page 12) will be erased in a few days.

To check the clock time

Press DISPLAY while playing any source.

• Each time you press the button, the source indication and the clock time alternate on the display.

DISPLAY

To adjust the clock again

If you have adjusted the clock before, you need to press

CLOCK/TIMER repeatedly until “CLOCK” is selected.

• Each time you press the button, the clock/timer setting modes change as follows:

DAILY

Canceled

ON TIME

(Daily Timer)

CLOCK

REC

ON TIME

(Recording Timer)

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:

1

Press CLOCK/TIMER.

CLOCK

/ TIMER

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

The hour digits start flashing on the display.

2

Press

4 or ¢ to adjust the hour, then press SET.

The minute digits start flashing on the display.

• If you want to correct the hour after pressing

SET, press CANCEL/DEMO. The hour digits start flashing again.

SET

– 9 –

02.5.21, 11:21 AM EN01-12.MX-K50[U].pm6

9